Voltage checks - puzzled and… UPDATE: operator error. I don’t deserve this amp

[e2o]

Thanks!! On it…

 

[e2o]

Ok, if it was black, it got wicked, inspected and re-soldered. Nothing looked loose, un-crimped, or chalky. Everything back together and readings are the same as above. Symmetrical, steady, same.
171, 383, 0, 383, 168 for 1-5;
0, 232, 0, 232, 0 for 6-10.

Another meter should be arriving tomorrow for verification.

Until then, anything in the physical assembly I should check?

Thanks,

- eric

 

[e2o]

OMG. As I posted in the update to the original post … I’ve been doing voltage readings in AC volts!! While browsing some other forum posts, I ran across a moderator comment asking another builder if that’s what they might be doing. OH THE SHAME!!!

I just sssumed “well that’s what comes out of the wall…(!)”

Thanks SO much to Paul Birkeland and Doc B. - you guys are awesome.

BY the way - it sounds absolutely lovely!

 

[Paul Birkeland]

Oh that's strange, usually the AC setting will read things really low.  I'm glad you got it figured out.

 

[Mucker]

Way to go getting it sorted out. Now go enjoy the awesomeness of the Crack!