LED Indicator

[Dr. Toobz]

With the tube shields on, it's hard to tell when the Seduction is running. Would there be any issue with sticking a common orange or red LED in one of the holes meant for the Hammond box (not needed in my case) and then running the LED, in series with a 1000 ohm resistor, in parallel with the two 6.3V tube heaters? I'm assuming this would only add about 20mA of current to the winding, depending on the LED?

 

[Paul Joppa]

Should be no problem.

 

[debk]

I did it with a blue LED.  worked great


Debra

 

[Pfenning]

Can someone give me a little instruction how to wire this in? I get the resistor and LED part, but where is the best place to tie it in?

Thanks, Pfenning

 

[randy@matrixq.com]

Would there be any problem using a 120V indicator lamp?  That should be easy to wire and wouldn't require a resistor to drop the voltage off the mains.  I'm pretty sure I have a few out in the garage in one of my bins full of parts.

 

[Grainger49]

An incandescent light, not neon, adds no noise.  Can you find one at 120V?

 

[Pfenning]

Found a 120 vac lamp at the Rat Shack in a 2 pack for $4. Had to drill out one of the existing unused mounting holes to 1/4" and slipped it right in. It worked really good, I might add one to all my Bottlehead gear. It's easier for my kids to see if it's on or off. I also bought some 3/16" black plastic hole plugs for the other 3 holes. Sounds silly, but it gave it more of a finished look.