Aural Robert
New member
I'm putting used Rega arm wiring into a different Rega RB250 and when the harness was removed from the original arm the wires were snipped. This stuff is awfully thin, my wire stripper doesn't go that small and I'm not sure how to strip them to solder them onto the next fiddly bit. I do have a solder pot. But there is not a lot of slack in the length of the wires and therefore NO room for error on my behalf, so I can't guess here I need to do it right the first time. Has anyone done this before? What is my best bet?
I have lurked on this board for years and know the knowledge base here is extremely talented, thus my post.
Any suggestions? TIA.
Aural Robert.
... HELP I need somebody ...
I have lurked on this board for years and know the knowledge base here is extremely talented, thus my post.
Any suggestions? TIA.
Aural Robert.
... HELP I need somebody ...