Smash Output Wiring.

[Chris65]

Hi, just a quick tech question - I noticed in the neat build thread by Stedes, that the 2 outputs are tied together on each side by resistors.
Just wondered the reason for that? Does that not attenuate the signal into the 2nd outputs (unless a very low value resistor).

Thanks,
Chris

 

[Paul Birkeland]

The resistor value is very, very low.  This was a suggestion from PJ, but I can't quite remember why...

 

[Chris65]

Thanks PB, I guess there's some reason....

 

[Stedes]

Hi all...would be interesting to know why. However to me (audibly) there is no difference between the two sets of outputs.