ALL212
New member
I've got my Stereomour built for 2A3's but would like to shift to 45's. I've got the June 16th, 2013 manual.
From the Manual:
Page 13 - I'll remove the 360 ohm resistors from the Power supply PCB.
Page 50 - I'll swap the plate choke blue and red wires. Red to A2, red to C2. Blues to 17L and 19L.
Page 66 - I'll remove the 4.7k 5W resistors from 6 and 16U, same at 10 and 20U.
but I've also found a post with corrections and I'm a bit lost there...
Blue wire from plate choke stays - no change.
It says the black (sometimes black/red) wire's aren't used - park them at 17 and 19. These are currently at HV+?
Here's where I'm really confused - red wires go to the HV+ terminals on the power supply board - use the HV+ Center hole. So I'm removing the black wires going to HV+ and using the red wires from the plate chokes in their place?
And last question - I used the third set of RCA's for pass through - just directly connected them to the selector. I've also read I should put a 1k ohm resistor in series here?
Thank you!
From the Manual:
Page 13 - I'll remove the 360 ohm resistors from the Power supply PCB.
Page 50 - I'll swap the plate choke blue and red wires. Red to A2, red to C2. Blues to 17L and 19L.
Page 66 - I'll remove the 4.7k 5W resistors from 6 and 16U, same at 10 and 20U.
but I've also found a post with corrections and I'm a bit lost there...
Blue wire from plate choke stays - no change.
It says the black (sometimes black/red) wire's aren't used - park them at 17 and 19. These are currently at HV+?
Here's where I'm really confused - red wires go to the HV+ terminals on the power supply board - use the HV+ Center hole. So I'm removing the black wires going to HV+ and using the red wires from the plate chokes in their place?
And last question - I used the third set of RCA's for pass through - just directly connected them to the selector. I've also read I should put a 1k ohm resistor in series here?
Thank you!