Resistance check failure

[Jburrows]

Just finished my Stereomour II build. Tried to do a resistance check, but I am getting no readings at all anywhere. Where do I go from here?
Obviously, I’m a new customer.

 

[Jburrows]

After rechecking I am getting some results.
Terminal 4 : 144
6 : 1.19
15 : 0
17 : 0
21 : 1.36
22 : 1.98
24 : 1.64
25 : 1.55

That’s as for as I’ve gotten so far

 

[Paul Birkeland]

What are the units on those numbers?

 

[Jburrows]

What are the units on those numbers?

The setting on my Klein was 2M ohms

 

[Paul Birkeland]

The Klein is a pretty annoying meter to use for this kind of work. It's really made for residential electrical work. This works a bit better and costs less.

If terminal 6 is 1.19M Ohm, that's a problem. If it's 1.19 Ohms, that's not a problem.

15 shouldn't be zero, definitely don't turn this amp on and post some build photos ASAP.

 

[Jburrows]

Spent today going over every solder. Did a lot of re soldering. At the end of the day the resistance numbers I got are all well within your 10-15% acceptable range. I also agree the Klein is not the best for this.
Thanks for your help.
FYI, terminal 6 is 1.1 Ohm today