How to use one of the output connections to a headphone amp?

[ALL212]

It's been sometime since I've been in here but I've been eyeballing that Moreplay for a while and with the sale going on I just had to bite. This will be my ... over 12 bottlehead kit build.

Where can I pull off the signal so that I can run the 2nd set of output RCA's to a Crack or Cracka-2-a? Could even end up on the Mainline.

I've not really studied the schematic yet... but hoping for some easy guidance before I start the build. I've got plenty to do so no hurry!

1) Paint the plate and bell.
2) Put together a new base - I've got a good selection of lumber so I just need to pick my species
3) Source some 2.2 uF caps - might be Clarity caps.. I like Sonicaps also. I have the upgrade - can I go down to 200v (Sonicaps) or 250v (Clarity CSA) on the 2.2's?

Any other fun upgrades from the crew here?

Thanks!
Aaron

 

[Larpy]

Run a second set of twisted pairs from the selector switch back to the second set of output jacks. Don't solder any resistors between the two sets of output jacks as the manual instructs.

In other words, wire two separate sets of R channel +/– and L channel +/– twisted pairs from the output lugs of the selector switch: one set will go the grids of the 6V6 tubes and the other set will go to the second set of output jacks. I recommend using a shielded cable.

 

[ALL212]

Sounds like what I've done in the past and I thank you!!