typos in SEX 4 manual v1.2
- Thread starter mete
- Start date
Given that there are only #8 lock nuts in the kit, that one can probably slide. We'll get the revision number updated with the next refresh though!
I have asked this in other thread but adding here just for the sake of keeping all my findings in the same thread:
At page 54 of the manual, for 230Vac (if your voltage is GREATER than 225V AC and LESS than 235V AC section), it says in the first step, "Attach the other end to 44U", this should be "Attach and solder". This issue exists for all 3 sections: (210Vac, 225Vac), (225Vac, 235Vac) and (235Vac, 250Vac).
At page 54 of the manual, for 230Vac (if your voltage is GREATER than 225V AC and LESS than 235V AC section), it says in the first step, "Attach the other end to 44U", this should be "Attach and solder". This issue exists for all 3 sections: (210Vac, 225Vac), (225Vac, 235Vac) and (235Vac, 250Vac).
On page 69, just before Power Supply Testing, second step first point, it says "Attach the unbanded end of a UF4007 diode to terminal 40U." and there is no other operation on 40U before Power Supply Testing. So it leaves 40U unsoldered during the test. I first thought it is just a mistake and it should be soldered but then I realized it is soldered on page 78 with a long black wire to 21U. As I dont like to perform testing with unsoldered connections, I first attached and soldered this long wire, meaning I also soldered 40U and then continued the Power Supply Testing. Maybe you also want to change it in the manual.
This is only a feedback: on page 70, power supply testing, last point is about unplugging the power cord and waiting for voltages to drop below 50V and it adds this can take 8+ minutes. I think 8+ minutes can be overlooked. It is written in red but still I would have preferred this to be written in big caps as it is dangerous.
