Staticky pot

[Jameson]

I'm having a little static when turning the volume pot, particularly at the low end.

I'm pretty sure I'd read somewhere that staticky pots are not uncommon and they may either take a little break-in to get the oxidization off, but was there also some sort of spray that was recommended? Or was it that spray wasn't recommended for pots?

 

[Paul Birkeland]

I wouldn't bother with spray on a new pot, just use it.  (Or install the attenuator upgrade)

 

[Jameson]

Sounds good. I've got the attenuator upgrade sitting here - wanted to get used to the base model first.

Kind of exciting to have two more sets of upgrades to make on this since it sounds amazing already!

 

[Doc B]

Exercise it by cranking it all the way up and down maybe 20 times to clear any oxidation. That is SOP in a studio when setting up gear for a recording.

 

[Jameson]

Yeah, I did do that. Probably just need to break it in some more.

 

[Jameson]

So, related to my other thread about the X2. I think this issue and the other are related. I noticed the quiet channel was also the channel with the static when the pot was turned. I swapped tubes and the issues followed.

Any chance that corrects itself with burn in? I ordered a few replacements on eBay - how important are matched ours of these?