I've just finished the assembly of my S.E.X. 3.0
There are some measurements that seem just a little bit off, namely H2, H5, H4 and H7.
The expected resistance is * (wandering in the 10Ks-100Ks), where mine are wandering around 200 Ohm. Is this ok?
Also the voltages for those are a bit high:
H2, H5: both 3.45V (should be +/- 2.8-3.2)
H4, H7: both -3.23V (should be +/- 2.8-3.2)
What does the +/- mean in the manual? My measurements are both + for H2 and H4 and both - for H4 and H6.
Additionally, I've got the problem that my multimeter only measures up to 250V. Is there something that I can do to measure the remaining terminals anyway or do I really have to buy a new meter?
The one I have is quite new too, but unfortunately I wasn't too careful when selecting a model.
There are some measurements that seem just a little bit off, namely H2, H5, H4 and H7.
The expected resistance is * (wandering in the 10Ks-100Ks), where mine are wandering around 200 Ohm. Is this ok?
Also the voltages for those are a bit high:
H2, H5: both 3.45V (should be +/- 2.8-3.2)
H4, H7: both -3.23V (should be +/- 2.8-3.2)
What does the +/- mean in the manual? My measurements are both + for H2 and H4 and both - for H4 and H6.
Additionally, I've got the problem that my multimeter only measures up to 250V. Is there something that I can do to measure the remaining terminals anyway or do I really have to buy a new meter?
The one I have is quite new too, but unfortunately I wasn't too careful when selecting a model.