Need some help, fuse blows

[jflorek]

yes

 

[Paul Birkeland]

Set your meter to AC voltage, then measure the AC voltage between power transformer terminals 1 and 2 with the amp plugged in and switched on.

-PB

 

[jflorek]

Meter set to AC, reading across pins 1 and 2 about 107

 

[Paul Birkeland]

Meter set to AC, reading across pins 1 and 2 about 107

Are you in Japan?

If you perform this same measurement and get no voltage between terminals 4 and 5 on the transformer, as well as terminals 9 and 10 on the transformer, then it's possible that you accidentally cut one of the wires that goes from terminals 1 or 2 on the transformer into the actual body of the transformer. 

This can be repaired with a scrap of wire and some solder if this is the case.