Hi all now that I am waiting for my FP3 manual any time now
I finally figured a way to install the pair of slagel avc physically on to the FP3. I entails some cutting of circuit board and wood work on the FP3. I am leaving the selector original.
The Slagel is a coarse/ fine unit with both volume control per channel mounted on a circuit board.
There are 3 points to solder on the board GND, IN, and OUT.
Before wiring I thought to get help and confirmtion
My take is the OUT of the Slagel goes to Terminal 17 (?) through a resistor an on to pin 2 of the 12AU7.
There is a black ground wire on left most terminal T 16 which connects to a resistor and then to T11 which is one black leg of the auricap ( looking from the tube side with transformer in the rear) I think that wire goes to Slagel GND
The original selector has a foil shielded Black wire with a red and black wire connected A and red to D of selector
My guess is that the black goes to Slagel GND so does the T- 16 black wire
The red wire goes from D (selector) to IN (of Slagel)
I will post before and after pics following this post as a reply
Thanks
I finally figured a way to install the pair of slagel avc physically on to the FP3. I entails some cutting of circuit board and wood work on the FP3. I am leaving the selector original.
The Slagel is a coarse/ fine unit with both volume control per channel mounted on a circuit board.
There are 3 points to solder on the board GND, IN, and OUT.
Before wiring I thought to get help and confirmtion
My take is the OUT of the Slagel goes to Terminal 17 (?) through a resistor an on to pin 2 of the 12AU7.
There is a black ground wire on left most terminal T 16 which connects to a resistor and then to T11 which is one black leg of the auricap ( looking from the tube side with transformer in the rear) I think that wire goes to Slagel GND
The original selector has a foil shielded Black wire with a red and black wire connected A and red to D of selector
My guess is that the black goes to Slagel GND so does the T- 16 black wire
The red wire goes from D (selector) to IN (of Slagel)
I will post before and after pics following this post as a reply
Thanks
