Crack Manual- Power Supply Assembly Question

[kevin flynn]

Hello,

New to Bottlehead. Recently purchased Crack kit, 6-28-10. Assembly OK, but at finish realize that the steps for completion of the power supply, i.e. addition of the three 220uf ps caps and last resistor are missing. Checking numbering of manual pages, print out is minus page 30. Supplied disc  manual page numbers are continuous, but doesn't show the section for completion of the power supply.

Any help / source for this section of manual? I'd rather not guess!

Thanks,

Kevin

 

[Paul Birkeland]

I know Doc and Eileen are around, I'd give them a call and see if they can e-mail you a complete manual.  I would do it, but I'm away from my machine with all the manuals, and mine are a bit out of date.

 

[grufti]

I just sent you a Private Message on this forum with a .png image of page 30.

 

[kevin flynn]

Got it... thanks Grufti.

Kevin

 

[shanman]

5/28 version manual is missing page 30 Filter Capacitors. Anyone know how/where I can get this?  I'm anxious to finish this project today.  Thanks

 

[druelle]

Was in the same situation but just came across this post by Doc B.:

Sorry about the missing page! Here's a link to it:

http://www.bottlehead.com/docs/Crack%20manual%20page%2030.pdf

 

[Grainger49]

There should be a sticky in each product's file with manual corrections, if needed. 

I know Doc has posted the corrections, but I don't think they have been "stuck."  They float down as new threads are entered.

 

[HF9]

bumping an old topic, but rebuilding a crack and my manual on CD does not have the elusive page 30 and I noticed the link is dead The steps missing are the fitment of the 220uf power caps in the power supply and the little yellow resistor, if I'm not mistaken. I'd imagine I could figure it out from final photos if no one has it, but I like to be sure everything is absolutely in it's right place before initial power on.

Thanks guys!

 

[Paul Birkeland]

bumping an old topic, but rebuilding a crack and my manual on CD does not have the elusive page 30 and I noticed the link is dead The steps missing are the fitment of the 220uf power caps in the power supply and the little yellow resistor, if I'm not mistaken. I'd imagine I could figure it out from final photos if no one has it, but I like to be sure everything is absolutely in it's right place before initial power on.

Thanks guys!

Shoot me a PM with your name and e-mail and I'll grab a link for you.

-PB