BeePre2 Build - DC Filament voltage high [resolved]

[dhherring]

Moving along with my BeePre2 build. Up until this point, all voltages have checked out and been within tolerance.

Completed the DC Filament Power supply, hooked it up and mounted onto the stand-offs.

But the voltages on the DC side are reading 8.4 volts - checked the AC side, and they both are reading 8.4 -8.5 as well.

My high voltage DC 31L and 33L is coming in at 264V.

House voltage is 122, and I did double check the wiring of the PT-6.

Any concern here, and if so, where should I be looking.

Thanks

Don

 

[Paul Birkeland]

Can you post some photos of your build?

-PB

 

[dhherring]

Good grief, what a stupid mistake........

I was checking the wrong pads - Doh.

I was checking the DC pads that are opposite the AC pads, not the Reg +- on the sides.

All good......

Sorry 'bout that.

Don