1 LED not lighting on speedball board after probable short (but voltages fine)

[billyshears]

Hi all.

I was doing a voltage check on the small circuit board and i assume i (clumsily) touched the 237Ω 1⁄8W resistor (in R1A) cause I got a spark when I went to test 1A.  Turned it off just to make sure everything looked okay.  The fuse was fine.  Plugged it back in and got the following voltages

0A: 66v
1A: 177v
A/B: ~0v
1B: 177v
0B: 66v

which are all in the acceptable range. however, the LED closest to 1A is not lighting up. I am uncertain as to what I should do.
passed glow test. no other issues prior.

Im a newbie to this stuff, so any help/suggestions on what to do next would be appreciated!

 

[Paul Birkeland]

Was that LED lit up OK before this incident? 

Can you post a photo of the PCB?

 

[billyshears]

pretty sure but maybe somehow i didn't realize. see attached. let me know if you need more pictures!

 

[Paul Birkeland]

Q1A is installed backwards.

 

[billyshears]

my brain did not let me see that. thanks so much!