Twin Plate load/servo pc boards-construction tip

A

azrockitman

New member
I'm curious if there is a strong consensus on whether to build both boards at the same time, or build one, then the other. 

Logic leads me to construct both boards simultaneously, since they are twins.  If I'm carefully following instructions, it seems like the chance for error would be lower by completing each step twice simultaneously; conversely I would think the chance for error higher if I was needing to read through those same instructions on two different occasions. 

Thanks
 
I built one at a time.  I think I took 6 or 7 short build evenings to build my Eros.  It was relaxing doing just a little at a time.  BTW, I built completely stock to begin with then after 2 months tried some capacitor rolling with jumpers.
 
You must log in or register to reply here.
Back
Top