Shunt Regulator Voltage Test Fail [resolved]

[Why1504]

First the voltage for D1 never dropped below 326.6. Only the 2 LEDs on the A side lit up.

D6 settled at 224.3 but again only 2 LEDs lit on the A side.

Please advise.

 

[Paul Birkeland]

Can you post the IA, IB, OA, OB, and both Kreg voltages?

 

[Why1504]

I can't now.  I have left my office where I am working on it.  I will go in early and check them and post tomorrow.

 

[Why1504]

Can you post the IA, IB, OA, OB, and both Kreg voltages?

IA. 327
IB.  327
OA. 224
OB. 325
KREG A. 4.999
KREG B. 32.25

 

[Paul Birkeland]

Can you confirm that you have a 431 regulator in the slot for Kreg B?  That voltage makes me think that it's in backwards, or an MPS4250 is installed in its place.

-PB

 

[Why1504]

The 431 is installed the same way on both sides with the flat to the outside.  Pins are installed the same on both.

 

[Paul Birkeland]

Well, little to no current is being drawn by half of the 12BH7.  This can happen due to a wiring or part installation error on the PC board, or a failure of the solder joint on pins 4 and 5 of that 9 pin socket.

Another issue that I believe will cause this type of problem is if Breg and +reg aren't jumpered on that side.

To check the pin 4/5 issue, you can look at the 12BH7 and see if there are amber glowing dots on each plate structure.

-PB

 

[Why1504]

I see 2 dots glowing on the top and 2 near the base of the tube.

 

[Paul Birkeland]

The next step I would recommend is to post some photos of that area.

-PB

 

[Why1504]

The jumper between the BReg and the +Reg is in place

 

[Why1504]

One of the 110k resistors wasn't soldered good.  As I was taking pictures it popped out.  Voltage now settlers to 223 and 224 respectively. All 4 LEDS light.

I think I am good.  Thanks for the help.