Robin Hood 2A3

[Paul Joppa]

Hey all, just a short note to say I put up a DIY design on Mike's board, using a 2A3 with the Robin Hood output transformer. Not parafeed or anything, just the simplest design I could do at the lowest cost - since the RH transformers are Mike's contribution to low-cost SETs.

http://www.audioasylum.com/forums/magnequest/bbs.html

Discussion should be on Mike's board, since this is not a Bottlehead thing at all. I only mention it because a lot of Mike's fans hang out here as well.  :^)