I upgraded the stock pot to an ALPS blue velvet. I am experiencing some slight channel imbalance shifted to the right. More bass resonance and rumble than the left. Also , the with pot maxed out to full there's no humming, however when i back it off to any other value there's a low hum in the right channel. I've checked all the solder points and my measurements are accurate to what is stated in the manual. Is this a tube related issue?
Right channel hum and imbalance.
- Thread starter Koop
- Start date
Did you listen to the amp with the stock pot first? Did you mount the Blue Velvet to a PC board? From which vendor did you buy your Blue Velvet?Koop said:
Yes. I originally bought the amp second-hand without Speedball installed a few years. I installed the speedball upgrade and all was good. About a month ago I took the entire amp apart and rebuilt it as it was starting to become noisy and wanted to paint the Chasis and base anyway. I bought the pot from Parts Connexion. 100K. I did not mount it to a PC board.
It's a PC board mount pot. When you mount wires right to those pins, the wires will tend to pull too hard on them and you'll damage the pot.
Did you do a voltage check when you rebuilt your amp?
Did you do a voltage check when you rebuilt your amp?
