Resistance Check Terminals 1, 4, 11, 12, 14, 25, 31, 33 [RESOLVED]

[Jimb0]

Hello,

I’m getting a reading of ~200K ohms on the following terminals: 1, 4, 11, 12, 14, 25, 31, and 33.
According to the manual:

• Terminals 4 and 12 should measure between 0–100K ohms.
• The others 1, 11, 14, 25, 31, 33 should read 0 ohms.

I’ve rechecked all connections multiple times and resoldered terminals 22–35, but the readings haven’t changed.

The photos came out upside down in the attachments so I am also posting these links to view them normally:

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[Jimb0]

I found the issue! The wire going into terminal 11 to terminal 1 broke off. I must over stripped the wire and then it broke off then I was bending the lead.