Thermioniclife
Member
Does the upgrade kit take the 9.4 Vac and output 6.3Vdc and removing the dropping resistors for the heaters?
Thanks in advance.
Thanks in advance.
Question regarding Moreplay upgrade kit.
- Thread starter Thermioniclife
- Start date
Yes.
Thermioniclife
Member
Roger that PB. i have a motorized Alps 10 k log pot from a failed / abandoned project that I can use to give remote volume control on the Moreplay..
being that I'm handicapped that would be cool. I use the Moreplay in my kitchen with a s3x and a pair of Overnight sensations, sounds good. IIRC Alps specs state 4.5 to 6.5 Vdc to operate the motor and I believe I measured the current draw of the motor was 50ma max. Can use a 7805 voltage reg to power a 2 channel IR relay board. Thanks for the reply.
Regards, Lee
being that I'm handicapped that would be cool. I use the Moreplay in my kitchen with a s3x and a pair of Overnight sensations, sounds good. IIRC Alps specs state 4.5 to 6.5 Vdc to operate the motor and I believe I measured the current draw of the motor was 50ma max. Can use a 7805 voltage reg to power a 2 channel IR relay board. Thanks for the reply.
Regards, Lee
If the current draw for the motor is that low, you can use the DC output from one of the heater regulators on the upgrade board.
