Power on right channel not quite right. Need suggestions

[Paul Birkeland]

We can set you up with a flat rate repair if necessary. 

The 7V at OC is a really bad sign.  That would basically mean no current is flowing through the 6922 half on that channel.  The 0.6V would be typical base emitter voltage which makes me wonder what's going on with the servo on that side.  PJ might have some good ideas here.

 

[last lemming]

I’ll pack up the unit and send it to you.  I’ll call about the rate Monday.

Thanks.

 

[last lemming]

Package sent to ya!

 

[Paul Birkeland]

We will not accept kits sent in your packing materials.  We have to send you the materials to do this.  You need to call about the service on Monday.

 

[last lemming]

Oh crap. Did not know that. I dropped it off at the UPS already. I’ll need to go pick it up

 

[last lemming]

Ok. Got the package back. I’ll call Monday.

 

[Paul Birkeland]

Thank you so much.  We used to allow people to send their own amps in, but the failure rate from poor packaging was over 90%, so we now send instructions and a proper box.

-PB