Here is a photo of my Pipette build.
It was a a lot of fun; about two to three hours of assembly time. The only minor issue that I encountered was the connector between the drivers and the binding posts. The connector did not fit very well with them and I am constantly worried about them falling off the spades of the binding posts or off the drivers. I may need to use pliers or something to get them to fit better.
Very fun project and they look fantastic. I am driving them with Stereomour at 8ohms; remember reading somewhere that Doc recommends using the 4ohms. May do that down the road but I am enjoying what is coming out right now.
It was a a lot of fun; about two to three hours of assembly time. The only minor issue that I encountered was the connector between the drivers and the binding posts. The connector did not fit very well with them and I am constantly worried about them falling off the spades of the binding posts or off the drivers. I may need to use pliers or something to get them to fit better.
Very fun project and they look fantastic. I am driving them with Stereomour at 8ohms; remember reading somewhere that Doc recommends using the 4ohms. May do that down the road but I am enjoying what is coming out right now.