Need Help Trouble Shooting intermittent loud distortion in left channel

[JDeiner]

I cheated and bought the already assembled reduction prototype unit from Bottlehead. I have built a stereomor and a Crack headphone amp. All three sound great.

I started losing a channel on the reduction about a month ago and ordered new tubes. The problem cleared up but now I am getting occasional loud distortion out of the left channel. It comes and goes and can be eliminated temporarily by turning the unit on and off again (totally annoying - loud pop and then the distortion goes away).

I switched the tubes  to see if they were the problem and the distortion still only came out of the left channel. I am assuming a bad cap, but I am not an expert and not sure where to start.

Any advice on troubleshooting this would be appreciated.

 

[Paul Birkeland]

If you bought the prototype from us, I would recommend returning it for repairs.  Otherwise a voltage check is the place to start, but often times the prototypes will vary just enough that the manual for the production kit isn't quite accurate.

-PB

 

[JDeiner]

Will do.

Thanks!