misadventure while doing build…to replace or not to replace part? Doc or Paul?

[Rabco]

I managed to chip or scallop a small part of the body of a 150K resistor at the R2B position of the Moreplay upgrade kit after I soldered it in place. Argh.

It looks like a divot or small superficial scoop that may have exposed an edge or corner of a plate(?) inside the resistor near one end. It might even be the edge of a color band. First time I’ve marred a component while/after stuffing a board. FWIW I use rounded conical tipped mini “needle” nosed pliers for board work.

I tested both soldered resistors at the R2B and R2C position for resistance and they both measured 75.2 if this info is useful or meaningful.

Should this be removed before I proceed? I haven’t really ever had to de-solder much of anything in my prior builds. I’ll see what I can find regarding de-solder/re-solder in the build videos if minds wiser than I (and not as clumsy ) think this component should be replaced.

Thanks in advance.

 

[Doc B]

Probably fine.

 

[Rabco]

Thanks Doc.
I’ll keep this on a possible suspect list if my results go sideways in the end.
Appreciate ya’.

 

[Paul Birkeland]

I would definitely leave it.  You're somewhat likely to damage the board, and a little chip out of the body of the resistor isn't going to cause any problems.

 

[Rabco]

Paul,
My thoughts exactly.
You gotta know when to hold ‘em, and when to fold ‘em.
I appreciate the advice.