Knobs ferchrissakes

Doc B

Former President For Life
Staff member
How the heck did the four of us who worked on this kit all fail to notice that we didn't have knobs listed on the packing list? Crikey.

They will go out in the mail Monday.
 
It happens. It's frustrating but it happens. If that's the worst thing that goes wrong the planet will remain on it's axis and current trajectory.
 
Fortunately, they're the last thing one installs and the amps will work perfectly fine without them.
 
Hello

I was wondering if the rubber rings that used to go at the base of the 300b in the version one are not included anymore for the version2. There is no more need for them?

Thanks

AB
 
Alby0521 said:
Hello

I was wondering if the rubber rings that used to go at the base of the 300b in the version one are not included anymore for the version2. There is no more need for them?

Thanks

AB

On a similar note, I have lead flask rings on top of the 300b's on the BeePre.  Will the BeePre 2 have an issue with  microphonics and need weights on the tubes also?

Thanks

Debra
 
Neither the lead rings nor the o-rings are partiuclarly useful with the BeePre 2. There's no harm in using them if you happen to have them.
 
I can hit the top plate of my prototype and hardly hear any microphonics with headphones on. Just the expected filament noise. It’s a significant improvement over the Beepre. I tried it with Herbies rings and the lead weights and didn't hear any noticeable improvement. The weights now sit on a few transformers.
 
They were about 1-1/4" OD.  Ultimately you'll get slightly better pin fitment into the sockets without them, and that for me would outweigh the non-existent benefit of using them in a BeePre 2.
 
Back
Top