Help with voltage check

[s0ap]

I've reread the manual and checked the wiring, as far as I can tell it's all correct.
All resistance checks were good. I am building the 120 volt version of the kit.
My problem is all the voltages are wrong, here is what differs from the manual.
1 - 240V
2 - 240V
4 - 240V
5 - 240V
7 - 0
9 - 0
13 - 240V
15 - 240V
21 - 240V
A1 - 240V
A6 - 240V
B1 - 240V
B2 - 240V
B3 - 0
B4 - 240V
B5 - 240V
B6 - 0
Neither of the tubes glow. I've never worked with electronics before and have no idea where to go from here.
Any help is much appreciated, Thanks.

 

[Paul Birkeland]

Try posting some photos of your build.

What wall voltage are you able to measure?

 

[s0ap]

I have 122 volts from the wall. Here are some pictures

 

[fullheadofnothing]

The lack of glow on the tubes is a strong hint that something is wrong with the heater circuit. The pictures don't show terminals 4&5 on the power transformer because the 270Ω resistor is in the way. Can you post a picture of those terminals?

 

[s0ap]

How does this look?

 

[Paul Birkeland]

Try measuring the AC voltage between power transformer terminals 4 and 5. 

 

[Rocketman248]

It looks like you've got B1 and B2 connected.  I don't believe they should be.

 

[Paul Birkeland]

Good catch on B1/B2.

It also looks like B3 may be wired to the wrong terminal (check the 2.49K resistors if this is the case, one may be really burned).

 

[i luvmusic 2]

Is there something in between B7 and B8?I could be wrong...

 

[Paul Birkeland]

Is there something in between B7 and B8?I could be wrong...

You could be very right.  If those terminals were shorted by a piece of wire, the outcome would be roughly the voltages listed above.