Josh cooked up a very cool adapter project for using headphones with StereomourIIs and Kaijus that have the DC filament supply-
http://bottlehead.com/the-blog/
http://bottlehead.com/the-blog/
Headphone adapter project for Bottlehead amps
- Thread starter Doc B
- Start date
denti alligator
New member
Would this work with the Stereomour II and Sennheiser HD600s?
fullheadofnothing
Moderator
Whoops. Note five somehow got chopped off the blogpost.
Fixed.
Fixed.
ALL212
New member
Just made this and it works as a great hum pot adjustment tool! I used the Switchcraft 1/4" adapter.
I plugged into my Stereomour and thought hmmm....hums a bit - needs shielding. Then realized that the hum pots were probably off. Small adjustments on the hum pots as I listened with volume at 0 and dialed them right in. Hum gone.
Very nice!
I was worried about the wires breaking off at the banana's. That's pretty small wire held down with a screw. As strain relief I just filled in the holes with hot glue. I know this makes it a one-off but for the cost of the banana's - not an issue.
I plugged into my Stereomour and thought hmmm....hums a bit - needs shielding. Then realized that the hum pots were probably off. Small adjustments on the hum pots as I listened with volume at 0 and dialed them right in. Hum gone.
Very nice!
I was worried about the wires breaking off at the banana's. That's pretty small wire held down with a screw. As strain relief I just filled in the holes with hot glue. I know this makes it a one-off but for the cost of the banana's - not an issue.
