denti alligator
New member
I re-flowed the terminals where I wasn't getting any resistance. And I ran some more tests.
Those same terminals (31, 36, and B2) are STILL not giving me any reading. At all. (Any thoughts on this?)
I tried the pot as suggested. With the bottom center pin I can't get a consistent tracking of numbers as I turn the knob. It cuts out at a couple points, but only for a split second and then starts tracking. Not sure if this is a sign of something wrong.
I plugged it back in and turned it on and it's fine. No screeching. Yet. I do, however, hear some slight noise with volume pot turned all the way up. But the noise is very slight, and I doubt I could hear it with music playing.
For now I will simply let it be. If it starts screeching or squealing again, I'll post back.
Those same terminals (31, 36, and B2) are STILL not giving me any reading. At all. (Any thoughts on this?)
I tried the pot as suggested. With the bottom center pin I can't get a consistent tracking of numbers as I turn the knob. It cuts out at a couple points, but only for a split second and then starts tracking. Not sure if this is a sign of something wrong.
I plugged it back in and turned it on and it's fine. No screeching. Yet. I do, however, hear some slight noise with volume pot turned all the way up. But the noise is very slight, and I doubt I could hear it with music playing.
For now I will simply let it be. If it starts screeching or squealing again, I'll post back.
