Dressing up an M6 termination

[EarWorm]

I'm looking for advice on terminating the Clarity Cap TC M6.  I want to place them up top on a new chassis and I'd like to terminate the studs so they are safe and covered and look nice at the same time.

 

[Paul Birkeland]

Drill two round holes in the chassis that will fit those cast protrusions that hold the M6 threads.  Buy M6 fiber fender washers, remove both nuts from both studs, then use the non-conductive washer to clamp the cap to your chassis plate.

It would be worth measuring those protrusions individually, as the manufacturer may allow for some variation in their exact position.

Your other option is to get a clamp and cut a large diameter hole in the chassis for the body of the cap to slide through.

-PB