Does it require to enlarge wood base for installing Dale 23 Step Attenuator?

A

audiblesoundwave

New member
I remember some of you had installed this attenuator but there was no mention of requiring any wood base work for installing this 23 step attenuator!

Does anyone have any experience?  I attached the link to eBay for the attenuator!

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=270311271326&ssPageName=STRK:MEWNX:IT

Thanks,
Milton
 
Thanks!

I remember this picture!  Still not sure it requires any wood base work for the attenuator from the picture.

Hope someone will step up and let us know!

Milton
 
I believe the length may not be the issue.  It is the width toward the edge of the wood base.  I like to find out do I need to file some wood away for getting the unit back into the wood base after the attenuator upgrade.

Thanks,
Milton
 
The depth is OK.  The diameter is close, depending on how far out the resistors extend.  I'm pretty sure it is Ok as is, but at worst you might have to chisel out a bit of the wall (I don't think so though).
 
Some sellers make these with the resistors mounted horizontally. Pretty sure these won't fit.  The vertical resistors should be OK.
 
I have a very similar attenuator, and had to chisel out some of the base in order for it to fit. The one pictured looks like the resistors are closer to the switch and may fit without modifying the base.
 
BNAL said:
I have a very similar attenuator, and had to chisel out some of the base in order for it to fit. The one pictured looks like the resistors are closer to the switch and may fit without modifying the base.
Click to expand...

At a hardware store or HD you can find a 2" or 3" rotary wood rasp that attaches to a drill.  That would make quick work of removing a little from the base.
 
Hi everyone,

With the inputs and advises from the forum, I went ahead and upgraded to the new 23-step attenuator that I purchased on eBay from the stock one!

Here is the link for the attenuator.  It took about two week to arrive.  http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=270311271326&ssPageName=STRK:MEWNX:IT

Here is the result.  The hole for the shaft needs to enlarge just a bit in order to get this version of attenuator through.  Also, (here was my question that started this thread) the wood base needs to be chiseled out some.  I have not done it yet.  The top plate would not completely fit back into the base for now.  I will need to get the tool for chiseling out the base tomorrow and I don
 
You must log in or register to reply here.
Back
Top