Clarification on the 10k uf cap mounting

[ALL212]

Bottom of page 46 - 6.3 electrolytic into the outboard holes of Y and Y+ on the B side.

The stack of three holes furthest from the mounting hole (bB) is NOT what I use.  The single hole closest to the mounting hole is Y?  The y+ side has no such confusion.  The picture shows using the single hole on the Y.

I'm going with the picture but since it says outboard hole and Y only seems to have 1 hole I'm just checking.

THanks!
Aaron

 

[Paul Birkeland]

The stack of three holes by bB is simply the connections to bB.

The Y+ and Y- (it's a bit easier to see the "-" on the other side of the board) are their own set of holes, with one set designed to fit a small resistor (33K in this case) and the other a bit heftier to support a capacitor.

 

[ALL212]

Thanks PB!  Much Appreciated.

Aaron