BeeTwoQuiet DC voltage [resolved]

[RestoredSparda]

Good afternoon!

Just completed the C4S board install and was wondering if my voltages are close enough at terminals 1 and 11. Instead of 150VDC I am reading 159.8 VDC.

Thanks!

 

[Paul Birkeland]

That's nothing to worry about.

 

[RestoredSparda]

Sounds good. Thanks Paul.

 

[PT]

Same here, but a hefty 185V on the 1 and 11 after installing the C4S on a BeePre2
120V on the 6 and 16. 4 LED's up and bright.
Line voltage 234V;
Should and where can I troubleshoot?

 

[Paul Birkeland]

Line voltage 234V;
Should and where can I troubleshoot?

No troubleshooting is required.  If you're wired for 230V, you could move one wire and go to 240V wiring if you'd like.

 

[PT]

Thanks!

 

[Roamconstant]

Paul- I'm in the same boat.  Just finished installing C4S board. 
I read 168V on terminals 1 and 11.
Terminal 6 is 165V.  Terminal 16 is 111V. 

Permission to move on to the second part of the quiet upgrade? 

 

[Paul Birkeland]

Yes, that is OK.

 

[Roamconstant]

Awesome.  Thanks as always.