Ok please don't shoot me. I spent a few hours looking on the forum and at headfi.
I got 2 12AT7's coming tomorrow from an ebay seller that was sending me 5963's he "upgraded" my order to these "rare" Sylvania 12AT7's...which from what I read have a high gain and aren't really a good thing to run in the crack.
So I thought I found a thread the other day on the forum where some folks have installed resistors on the speedball boards to allow the plate voltages to be within tolerance so they can be used...even though this would cause the other normal tubes to be out of their optimal voltages?
So the long story short, is there a simple resistor value change to allow the 12AT& to run or not??
If there is a thread that I have missed would you please point me to it or shuld I just return the tubes?
Thanks
Alex
I got 2 12AT7's coming tomorrow from an ebay seller that was sending me 5963's he "upgraded" my order to these "rare" Sylvania 12AT7's...which from what I read have a high gain and aren't really a good thing to run in the crack.
So I thought I found a thread the other day on the forum where some folks have installed resistors on the speedball boards to allow the plate voltages to be within tolerance so they can be used...even though this would cause the other normal tubes to be out of their optimal voltages?
So the long story short, is there a simple resistor value change to allow the 12AT& to run or not??
If there is a thread that I have missed would you please point me to it or shuld I just return the tubes?
Thanks
Alex